This Q-code is used to indicate that the communication is ending. You can use it as a verb as DXing and say “I’m DX-ing today” or as an adjective and say, “that was a DX QSO.” A hobbyist who likes listening to far-away radio stations is called a DXer. It means a far-away station that is hard to hear in a specific location and frequency. The “D” represents distance, and “X” means unknown. While it’s not necessarily inappropriate to use it with strangers, it’s best to be cautious. This one is used to say “love and kisses.” It’s a bit more intimate than 73 and is common among close friends and family. You can use it when signing off or when you want to say goodbye. This term says “best regards” or “best wishes.” It’s a friendly way to end a conversation. Here are some of them together with their meaning. When checking into a repeater, amateur radio band, or listening to the ham radio band with a scanner, you will discover a lot of jargon. Radio_Communication_Terms”>Ham Radio Communication Terms When followed by a question mark, the Q-signal turns into a question- QTH? Asks the question, “What is your location?” QTH stands for “My location is _.” So, when you send QTH Florida, you tell the other operator that your location is in Florida. For instance, “QRZ ” means “You’re being called by. QRZ is a Q code that a radio operator uses to ask “Who’s calling me?” or indicate that a particular person is calling. For example, “I can communicate with QSO directly” or “can you communicate with QSO directly?” QRZ As a statement, it means “stop sending.” And as a question, “should I stop sending?” QSO This code asks the other frequency whether it is okay to get off-air and states that you are about to get off the air. For example, QRV?: “Are you ready?” QRV: “I’m ready. Nowadays, it shows that a station is ready to go on air or to ask if one is prepared to go on air. Initially, this meant that a station was ready to copy a message. When sent this code, it is only courteous to slow down. You can use this code to ask whether to send slower codes or as a statement to alert the other ham to send slower codes. For instance, QRU: I have nothing for you, or QRU?: Do you have anything for me? QRS They probably also mean this if they send QRU. Today, you’ll sometimes hear stations say, I AM QRU, meaning that unless you have something further to say, they wish to end the radio communication. They would use this Q-signal to notify the other operator that they had no messages or ask if they had any messages to pass. This Q-signal was common among amateurs sending and receiving radiograms. An example is: QRP (I will decrease power) or QRP? (Shall I reduce the transmitter power?). Your transmitter output power must be 5 W or less to qualify for the QRP category. If someone says, RIG HR IS QRP, they mean the transmitter’s power output is 5 W or less.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |